research
 Patents
 Books
 Literature
 Articles
 Timeline
 Auction Archive

about
 About this site
 Wanted to buy

bulb gallery

Incandescent:
C
carbon
WD
drawn tungsten
WC
coiled tungsten
WM
mini tungsten
WS
pressed tung.
FG
figural bulbs
XL
christmas
XS
christmas sets
T
tantalum

Discharge:
NE
neon lamps
AR
argon lamps
XE
xenon lamps
MA
mercury
MC
fluorescent
MS
special mercury

Hardware:
F
fuses
FX
fixtures
PF
plugs & fittings
SA
sockets
SW
switches

tube gallery

 X-ray
 Geissler
 Crookes
 Radio
 Box art

museum pics

 Dr. Hugh Hicks
 
Fort Myers, FL.
 S.Slabyhoudek

links

 Related links
 Submit a link

 

Author Topic: Dumet Wire Questions  (Read 17617 times)

Offline Tedd

  • New Member!
  • *
  • Posts: 2
    • http://home.earthlink.net/~teddp/
Dumet Wire Questions
« on: June 29, 2000, 09:12:00 pm »
Can anyone tell me, or refer me to another resource, when was "dumet" wire
invented, and when did it become widely used?

I have a Crookes (evacuated electrical discharge) tube which has wires
used to make glass-to-wire seals.

The wires:

- look coppery where they are not in contact with anything inside the tube
- look red/brown where sealed in glass
- in one case appear to be spot-welded to another piece of metal inside the tube

Does this description suggest "dumet" wire, or possibly some other?

I'm hoping to use info about this wire to help determine the age of the Crookes tube.

Thank you very much for any info,

Tedd

Offline Dave

  • Jr. Member
  • **
  • Posts: 30
Dumet Wire Questions
« Reply #1 on: July 01, 2000, 11:17:00 pm »
I can't say that I am familar with Crookes tubes, but I can explain about the sealing of incandescent lamps and it could be similar to what you have. Dumet wire was first put into use around 1914, when it replaced platinum. A good type of metal is needed for the lead in wires through the stem press in order to mantain vaccum in the lamp. Right from the very early days of incandescent lighting, it was/is known that platinum "wets" the glass in the stem press, and this is a good sealant, so that the vaccum/gas won't leak out when the lamp cools and the wires contracts. Unfortunately platinum is an expensive material...so a reliable replacement had to be found. Several materials were used, but none proved to be good. Finally, it was found that conventional lead in wires coated with copper made a good sealant, and was cheaper to manfacture, and as I said, it was put into wide use in 1914 and is still in use today.
DMD

Offline Tim

  • Administrator
  • Hero Member
  • *****
  • Posts: 831
    • http://www.bulbcollector.com
Dumet Wire Questions
« Reply #2 on: July 06, 2000, 05:33:00 pm »
Tedd,

I took a closer look at the tubes I have and found one with what looks like Dumet lead-in wires - see the picture below. Coincidentally (?) it's also the only tube I have that's a dud - it refuses to light depsite being in perfect physical condition  

Even though Dumet was developed around 1913-1914 I bet it wasn't used in Geissler tubes until several years later. Can anyone confirm this? I'm just guessing.......


 

------------------
-Tim