research
 Patents
 Books
 Literature
 Articles
 Timeline
 Auction Archive

about
 About this site
 Wanted to buy

bulb gallery

Incandescent:
C
carbon
WD
drawn tungsten
WC
coiled tungsten
WM
mini tungsten
WS
pressed tung.
FG
figural bulbs
XL
christmas
XS
christmas sets
T
tantalum

Discharge:
NE
neon lamps
AR
argon lamps
XE
xenon lamps
MA
mercury
MC
fluorescent
MS
special mercury

Hardware:
F
fuses
FX
fixtures
PF
plugs & fittings
SA
sockets
SW
switches

tube gallery

 X-ray
 Geissler
 Crookes
 Radio
 Box art

museum pics

 Dr. Hugh Hicks
 
Fort Myers, FL.
 S.Slabyhoudek

links

 Related links
 Submit a link

 

Author Topic: Drilling into a vacuum tube  (Read 22400 times)

Offline buzz

  • New Member!
  • *
  • Posts: 1
Drilling into a vacuum tube
« on: May 18, 2008, 08:45:39 pm »
Has anyone drilled a hole in the base of a vacuum tube?
I'd like to make a light fixture out of several large tubes, by inserting one or more LEDS into the base.  Are there any hazards (other than the potential for broken glass) in do this?

Offline oz4s11

  • New Member!
  • *
  • Posts: 5
Re: Drilling into a vacuum tube
« Reply #1 on: May 29, 2008, 03:32:20 pm »
Never tried it; if you break the glass you'll destroy the getter material inside, which would make the tube unsightly.

Assuming the tube has a plastic base (bakelite), I'd definitely recommend the use of a drill press so you can control the depth of the drill into the plastic, so as to avoid breaking the the glass nib on the bottom. You could even construct a drill bit limit in the form of a plastic or copper tube cut to the depth needed and placed around the  drill.

An alternative to using the drill bit might be to use a copper tube chucked into the drill press and continuously feed automotive valve grinding compound into the base/copper tube interface until you penetrate.

Or maybe an end-mill which would result in minimal penetration into the material.